Embellish Fusible Bold Tearaway 12 X 10 yards - 844050018093
Skip Navigation Website Accessibility
212 S. 4th St.    Cañon City, CO.   719-285-8088
805 Eagleridge Blvd. #140   Pueblo, CO 719-225-8142

Family Owned and Operated Since 2012
Authorized and Certified Dealer for
Baby Lock • Brother • Janome
Sewing & Embroidery Machines
"Your Hometown Sewing Store"
 


Embellish Fusible Bold Tearaway 12" X 10 yards

left in stock in

Low in store inventory, may be subject to change

Fusible Heavy Tearaway for Solid Support
Embellish® Fusible Bold Tearaway is a tightly woven, heavy duty, fusible stabilizer made using a unique “Non-Woven” technique. The fusible coating is temporary, so it pulls away easily when ironed at the proper temperature. It is used to support decorative sewing stitches and large or dense embroideries on stable woven fabric such as: cotton, duck cloth, twill, and denim. It features a multi-directional tear capability, easily pulling away clean from the embroidery design, for a crisp look on the front and back. Also available in a non-fusible version, which is to be used as additional support by floating a piece under the embroidery hoop when the design stitch count is more than one layer of Embellish® Fusible Bold Tearaway can sustain.



Holds up to 12,000 embroidery stitches in a 4”x4” hoop.

To Use:

  1. Fuse one layer of the stabilizer to the back of the material. Be sure to use a piece at least one inch larger than the outer perimeter of the hoop to ensure proper stabilization.

    Important – Use a low temp (Silk Setting) on your iron. Do NOT touch the surface of your iron to Embellish® Fusible Bold Tearaway, press from the fabric side or use a press cloth (natural fibers such as muslin or cotton). All irons heat differently. The iron temperature given is a starting point. If you find that you are not getting a good fuse, slowly increase your iron’s temperature until you achieve a good bond between the fabric and stabilizer and ensure the stabilizer can be torn away easily. If it won’t release easily when torn away, the iron temperature is too high.

  2. Hoop the material along with the fused stabilizer, making sure the material and stabilizer are taut.
  3. If the design has more than 12,000 stitches in a 4”x4” hoop then “float” a piece of non-fusible Embellish® Bold Tearaway under the hoop for added support.
  4. Add an embroidery topper on top of the hoop (either Embellish® Rinse-Away Clear Topper or Embellish® Iron-Away Clear Topper).
  5. Embroider the design.

To Remove:

  1. Remove the material from the hoop. Remove the topper, following the topper product sheet, found in the workbook.
  2. Hold your fingers over the bobbin thread and tear away as much of the stabilizer as possible, starting with the “floater,” if applicable.
  3. If the iron temperature was too hot during the fusing process, it might be necessary to re-heat the stabilizer, using a Silk Setting for it to release from the material.